2D Vector Snapping Modes

2D Vector Snapping Modes

The snapping modes available allow you to click to precise geometrical points on a drawing. For example, if you select Snap to end-point and you move the cursor over an end-point of a line, the end-point will be highlighted by a snap box.

The snapping modes allow you to snap to the mid, center and end-points of an entity:

Button

Snap to

Description

End-point

Geometric snap mode where a snap box appears when moving the cursor near a linear component’s end point.

Mid-point

Geometric snap mode where a snap box appears when moving the cursor near the halfway point of a linear component.

Center-point

Geometric snap mode where a snap box appears when moving the cursor near the center of an elliptical component.

Free snap

Allow snapping at any point on the drawing.

Button	Snap to	Description
	End-point	Geometric snap mode where a snap box appears when moving the cursor near a linear component’s end point.
	Mid-point	Geometric snap mode where a snap box appears when moving the cursor near the halfway point of a linear component.
	Center-point	Geometric snap mode where a snap box appears when moving the cursor near the center of an elliptical component.
	Free snap	Allow snapping at any point on the drawing.

http://www.oracle.com/applications/autovue/index.html
Voice: (514) 735-3219
Fax: (514) 735-6440
info@cimmetry.com
Copyright © 1989, 2008, Oracle and/or its affiliates. All rights reserved.
Notices and disclaimers