Home > Scan > Scan Using the Scan Button on Your Fuji Xerox Machine > Scan Photos and Graphics

Scan Photos and Graphics

Send scanned photos or graphics directly to your computer. Fuji Xerox's ControlCenter software will launch the default graphics application on your computer and open your scanned document automatically.

Use the Scan button on the machine to make temporary changes to the scan settings. To make permanent changes, use Fuji Xerox's ControlCenter software.

  1. Load your document.
  2. Press (Scan).
  3. Press or to select the Scan to PC option, and then press OK.
  4. Press or to select the Image option, and then press OK.
  5. If the machine is connected over the network, select the destination computer.
  6. Press OK.

    If the LCD prompts you to enter a PIN, enter the four-digit PIN for the destination computer on the LCD.

  7. Do one of the following:
    • To change the scan settings for this document, press or to select Yes, and then press OK. Go to the next step.
    • To use the default scan settings, press or to select No, and then press OK. Press Start.

      The machine starts scanning. If you are using the machine's scanner glass, follow the LCD instructions to complete the scanning job.

    • In order to change scan settings, Fuji Xerox's Control Center software must be installed on a computer connected to the machine.

  8. Select the scan settings you want to change:
    • Scan Type
    • Resolution
    • File Type
    • Scan Size
    • Remove Bkg. Clr

      (available only for the Color and Gray options.)

  9. Press Start.
    The machine starts scanning. If you are using the machine's scanner glass, follow the LCD instructions to complete the scanning job.
Related Information

Go to top of page